MotoSAT Nomad 2 Spezifikationen

9TROUBLESHOOTING ERROR CODES ARE FLASHING LED LIGHTS AT 1 SECOND INTERVALS Stow Flashing: This is not an error but motors moving. Find Flashing: I

10

11Special Notes Stowing the dish when all else fails. If you are able to go onto the roof - 1. Unplug the “Green” 9 pin connector from the back o

12 RAIN FADE ON DOME SYSTEMS Read all about it…………. Subject: Rain fade on Domed (Covered) Systems What is rain fade? Rain fade is signal

13WIRING TABLE Open Face TV Mounts The Control Cable, 9 conductors, colored coded, 22Awg stranded that connects to the mount with a twist lock conne

14 Satellite Mode Guide Dish Network, Bell Express Vu Modes and Dishes Use the “Find” and “Stow” Buttons

15

16

17 Nomad 2 Quick GuideWe have introduced an exciting new product, the Nomad 2. It has incorporated all the features that you (the dealer and consum

119 July 2006 NOMAD 2 UNIVERSAL CONTROLLER USER INSTRUCTIONS MANUAL The NOMAD 2 Universal Controller gives an all new meaning to the word simplicit

2NOMAD 2 Universal Controller Bill of Materials: The NOMAD 2 Universal Controller Systems (when shipped with a mount of choice) are shipped with the

3Using the NOMAD 2 Universal Controller First Time Installation: 1- Plug in all necessary cable connections to the back of the NOMAD 2 (see dia

4 4- To run the “MANDATORY” Test Dish function, hit the power button, wait 10 seconds for the Nomad to finish the startup sequence then, press

5To initiate a REPEAK – Skewable Mounts ONLY - Pressing the Find button, when “on satellite” and the signal strength shows weakness, will re-peak the

6 OPERATION PROCEDURES TO FIND A SATELLITE If the Mount Type is SKEWABLE (Models MD500 and MHDTV) 1. Turn ON power. 2. After 10-15 seconds (aft

7NOMAD 2 UNIVERSAL CONTROLLER “REAR” PANEL Power Supply Interface: Is used to connect the 12 VDC 4 AMP power supply to provide power to the NO

8Serial Port: Used to provide software upgrades. From Dish: Coax connection from the dish to the NOMAD 2 Universal Controller. To Satellite “IN”